Users Manual
Table Of Contents
- /
- ENGLISH
- NAVIGATOR TXT MULTIHUB TECHNICAL MANUAL
- 1 Revision of the Manual
- INTRODUCTION
- 2 LEGEND OF THE SYMBOLS USED
- 3 SAFETY RULES
- 4 OPERATION OF THE RADIO DEVICES
- 5 ENVIRONMENTAL INFORMATION
- 6 NORMATIVE INFORMATION
- 7 NAVIGATOR TXT MULTIHUB
- 8 DESCRIPTION
- 9 TECHNICAL FEATURES
- 10 DISPLAY
- 11 POWER SUPPLY
- 12 POWER ON/OFF
- 13 COMMUNICATION
- 14 DIAGNOSIS
- 15 FIRMWARE UPDATE
- 16 MAINTENANCE
- 17 TROUBLESHOOTING
- 18 LEGAL NOTICES
- ENGLISH
11.1.1 OBD socket
Power can be supplied to the VCI via the OBD socket of the vehicle being tested, by
connecting a specific diagnostic cable to the DIAGNOSIS connector.
The image is only an example: the position of the OBD socket
and the type of diagnostic cable may change based on the
vehicle being tested.
Always refer to the documentation supplied by the vehicle
manufacturer for the positioning and correct access to the
OBD socket.
Always refer to the indications provided by the diagnostic
software for the selection of the diagnostic cable to use.
Proceed as follows:
1.
Connect the diagnostic cable to the DIAGNOSIS connector.
2.
Connect the diagnostic cable to the vehicle's OBD socket.
3.
Turn the vehicle's ignition key on ON (instrument panel on).
The VCI displays the following screen if no communication modes with the display unit have
been configured.
26