Users Manual
Table Of Contents
- /
- ENGLISH
- NAVIGATOR TXT MULTIHUB TECHNICAL MANUAL
- 1 Revision of the Manual
- INTRODUCTION
- 2 LEGEND OF THE SYMBOLS USED
- 3 SAFETY RULES
- 4 OPERATION OF THE RADIO DEVICES
- 5 ENVIRONMENTAL INFORMATION
- 6 NORMATIVE INFORMATION
- 7 NAVIGATOR TXT MULTIHUB
- 8 DESCRIPTION
- 9 TECHNICAL FEATURES
- 10 DISPLAY
- 11 POWER SUPPLY
- 12 POWER ON/OFF
- 13 COMMUNICATION
- 14 DIAGNOSIS
- 15 FIRMWARE UPDATE
- 16 MAINTENANCE
- 17 TROUBLESHOOTING
- 18 LEGAL NOTICES
- ENGLISH
Connector Used for Power Supply Connector Used for Voltage Reading Icon
DIAGNOSIS DIAGNOSIS
PWR PWR
DIAGNOSIS + PWR DIAGNOSIS
The following values are displayed:
•
instantaneous
•
maximum[Max.]
•
tickover[Min.]
In case of dual power supply, if the voltage read via the
DIAGNOSIS connector drops below a given threshold, the
displayed values refer to the voltage on the PWR connector.
10.3 Status
This area shows the status of the VCI.
Status Display
The VCI is turning on.
The VCI warranty has not been activated yet.
The VCI is awaiting commands.
The VCI is ready to carry out a STANDARD diagnosis.
The VCI is ready to carry out a DoIP diagnosis via Wi-Fi.
The VCI is ready to carry out a DoIP diagnosis via network cable.
The VCI is in Pass-Thru mode.
The VCI is being configured for the dynamic tests.
The VCI is recording the desired parameters.
Blinking: it indicates that the VCI is active.
23
en