User's Manual

MT_Navigator_TXB_EN_00 Texa S.p.a.
19/ 22
2 HOW TO SUPPLY NAVIGATOR TXB
NAVIGATOR TXB can be supplied:
1. Through the connection of the diagnostic port of the motorcycle
under examination
2. Through the auxiliary cable, for direct connection to the battery.
If the tool is connected correctly, the green LED will turn on.
NOTE:
Since NAVIGATOR TXB does not have an internal battery, it is advisable to
make sure that the tool is correctly supplied.
Do not use batteries external to the vehicle, and electrically disconnected
from the motorcycle undergoing diagnosis.
2.1 Supply Through the Diagnostic Port
Simply connect the tool to the diagnosis port of the motorcycle under
examination through the specific connector to supply NAVIGATOR TXS.
2.2 Supply Through Battery Auxiliary Cable
To supply the unit through connection to the motorcycle's battery, it is
necessary to use the auxiliary cable included below.
This cable needs to be connected to the PWR connector of NAVIGATOR
TXB.
When connecting the cable clamps to the battery terminal, pay attention
to the polarity.
A LED on the cable turning on indicates the presence of power supply.
WARNING