User's Manual

MT_NAVIGATOR_TXS_EN_00 Texa S.p.a. 18/ 22
2 HOW TO SUPPLY NAVIGATOR TXS
NAVIGATOR TXS can be supplied:
1. Through the connection of the diagnostic port of the vehicle under
examination.
2. Through the auxiliary cable, for direct connection to the battery.
If the tool is connected correctly, the green LED will turn on.
NOTE:
Since NAVIGATOR TXS does not have an internal battery, it is advisable to
make sure that the tool is correctly supplied.
Do not use batteries external to the vehicle, and electrically disconnected
from the vehicle undergoing diagnosis.
2.1 Supply Through the Diagnostic Port
Simply connect the tool to the diagnosis port of the vehicle under examination
through the specific connector to supply NAVIGATOR TXS.
2.2 Supply Through Battery Auxiliary Cable
Power supply can be provided also through the auxiliary cables listed below.
These cables need to be connected to the PWR connector of NAVIGATOR
TXS.
2.2.1 Battery Cable
This cable allows to connect directly to the vehicle's battery.