User's Manual

11.2 Configuration
The configuration of the vehicle is automatic, nevertheless you should verify the
connection to the control unit and to the display unit by means of the flashing
LEDs before repositioning plastic parts or panels.
After the check, reposition all the plastic parts and panels previously removed.
Do not start driving before the plastic parts and panels removed are
repositioned correctly.
DISPLAY UNIT'S BLUETOOTH NOT ACTIVE
Proceed as follows:
1.
Turn on the vehicle's instrument panel.
2.
Make sure the device's green LED goes through the following statuses:
Double flash
Configuration in progress.
Quick flash Device configured, waiting to communicate with the vehicle.
Slow flash
Device configured and communicating with the vehicle.
Normal operation.
At this point the device is ready for use.
DISPLAY UNIT'S BLUETOOTH ACTIVE
Proceed as follows:
1.
Make sure the display unit's Bluetooth is active.
2.
Turn on the vehicle's instrument panel.
3.
Make sure the device's green and blue LED flashes alternately.
4.
Launch the specific app for the connection to the device.
5.
Start the procedure for the connection to the device.
6.
Enter the PIN when requested by the app (the PIN is printed on the device's label
and on a sticker applied to the product's box).
7.
Make sure the device's blue LED goes through the following statuses:
Double flash
Configuration in progress.
Quick flash Device configured, waiting to communicate with the vehicle.
Slow flash
Device configured and communicating with the vehicle.
Normal operation.
At this point the device is ready for use.
For further information consult the Blink Codes chapter.
21
en