User's Manual
Table Of Contents
- /
- ENGLISH
- DATAPLUG TECHNICAL MANUAL
- Review of the Manual
- INTRODUCTION
- 1 ABOUT THE MANUAL
- 2 LEGEND OF THE SYMBOLS USED
- 3 GLOSSARY
- 4 SAFETY RULES
- 5 OPERATION OF THE RADIO DEVICES
- 6 REGULATORY INFORMATION
- 7 DATAPLUG
- 8 DESCRIPTION
- 9 POWER SUPPLY
- 10 LOCATION OF THE DIAGNOSTIC SOCKET
- 11 INSTALLATION AND CONFIGURATION
- 12 USE
- 13 MAINTENANCE
- 14 BLINK CODES
- 15 TROUBLESHOOTING
- 16 TECHNICAL FEATURES
- 17 ENVIRONMENTAL INFORMATION (For the European Union)
- ENGLISH
You might have to disconnect the device form the OBD socket during vehicle
maintenance operations in order to allow the connection of diagnostic devices.
In this case, use the specific extractor tool.
Proceed as follows:
1. Turn off the vehicle (ignition key off).
2. Carefully remove any panels cover the OBD socket.
3. Apply the extractor tool to the device.
4. Carefully pull out the device until it disconnects completely from the
diagnostic socket.
If you do not have the extractor tool, use your bare hands to carry out this
operation.
Do not use screwdrivers or other tools to lever and disconnect the
device.
20