User's Manual
Table Of Contents
- /
- ENGLISH
- DATAPLUG TECHNICAL MANUAL
- Review of the Manual
- INTRODUCTION
- 1 ABOUT THE MANUAL
- 2 LEGEND OF THE SYMBOLS USED
- 3 GLOSSARY
- 4 SAFETY RULES
- 5 OPERATION OF THE RADIO DEVICES
- 6 REGULATORY INFORMATION
- 7 DATAPLUG
- 8 DESCRIPTION
- 9 POWER SUPPLY
- 10 LOCATION OF THE DIAGNOSTIC SOCKET
- 11 INSTALLATION AND CONFIGURATION
- 12 USE
- 13 MAINTENANCE
- 14 BLINK CODES
- 15 TROUBLESHOOTING
- 16 TECHNICAL FEATURES
- 17 ENVIRONMENTAL INFORMATION (For the European Union)
- ENGLISH
11 INSTALLATION AND CONFIGURATION
The following chapters illustrate how to install and configure the device.
The device can be installed only on Volkswagen vehicles indicated in the
specific coverage list.
Do not install the device on vehicles not expressly indicated in the
specific coverage list.
11.1 Installation
A screwdriver may be needed to loosen the screws that fasten the
panels that cover the OBD socket.
Proceed as follows:
1. Turn off the vehicle (ignition key off).
2. Locate the OBD socket.
3. Carefully remove any panels cover the OBD socket.
4. Connect the device to the OBD socket.
5. Turn on the vehicle (instrument panel on).
6. Make sure the device is securely connected to the diagnostic socket to avoid
it from accidentally disconnecting during use.
Make sure that the various components around the diagnostic
socket do not damage the device during installation.
Make sure that the position of the device does not interfere with
driving.
19
en