User Manual

8 • ULTIMA 40 ACTIVE NG
Remote Control
Inserting/changing the batteries
The remote control is powered by 2 type AAA
batteries.
1. To open the battery compart-
ment, carefully screw the lid off.
2. If applicable, remove the old
batteries and dispose of them
in an environmentally-friendly
manner.
3. Slide the new batteries into the
battery compartment according
to the image on the back of the
remote control.
4. Screw the lid back closed – it
only fits the right way around and is slightly under
tension from the springs.
NOTICE
When inserting the batteries in the compart-
ment, make sure that the polarity is correct.
CAUTION
Batteries can explode if handled improperly.
Never attempt to recharge batteries.
Only use batteries of the same or equiva-
lent type.
You must not heat, short circuit batteries
and rechargeable batteries, dispose of
them in fire or expose them to direct
sunlight.
Leaking battery acid may lead to chemical
burns.
Do not allow battery acid to come into
contact with skin, eyes or mucous
membranes. In the event of contact with
acid, immediately flush the applicable
areas with plenty of clean water and
consult a physician if necessary.
(26)
Night mode on/off
(27)
Mute on/off
(28)
+ Increase volume and menu
navigation up
(29)
Decrease volume and menu
navigation down
(30)
Access the menu
(31)
Adjust brightness after fading/
dimming
(32)
Dynamore Center on/off
(33)
TV Select TV as source via HDMI
ARC
(34)
AUX Select analogue source AUX IN
(35)
INFO Display current system para-
meters
(36)
USB Select PC as the source via the
sound card
(37)
OPTICAL Select digital source OPTICAL IN
(38)
BLUETOOTH Select the Bluetooth
®
source,
start pairing
(39)
TREBLE Adjust high tones
(40)
BASS Adjust low tones
(41)
Back button
(42)
Start/pause playback
Works for Bluetooth
®
- for all
other sources the Start/pause
is “mute”
(26)
(27)
(28)
(29)
(31)
(39)
(32)
(33)(38)
(34)(37)
(35)(36)
(30)
(40)
(41)
(44)
(42)
(43)
(43)
Skip track and menu navigation
left/right
(44)
Switch the device on and to
standby