Operating instructions

• Impaq® 3000 Mk 2 Blu-ray
10
Mounting on the speaker stand M 50 P
• As the speaker is quite high, it must be mounted on the
speaker stand so that the key hole opening is located
under the connector terminals. Otherwise the speaker
would bump into the diagonal stand tube.
• Remove the protective grid from the speaker bycare-
fully taking hold of it from behind and slowly pulling it
off to the front.
• Turn the protective grid by 180° and put it back in place.
• When positioning, make sure that the installation
pins slide exactly into the corresponding jacks on the
speaker.
Connecting the speakers
Use the enclosed coloured speaker cables to connect the
speakers. You can order longer cables if you need them
in our webshop (www.teufelaudio.com) in the “Accesso-
ries” area.
16
The coloured connector terminals 16 “Speakers” for the
six speakers are located on the back side of the receiver:
Colour Speaker Label
White/black Front left FL
Red/black Front right FR
Green/black Center CENTER
Blue/black Rear left SL
Grey/black Rear right SR
Purple/black Subwoofer SUBWOOFER
The speaker terminals and the enclosed speaker cables
are like coloured.
Make sure that the polarity is correct!
Connect the like-coloured terminal clips with
one another. Otherwise, the sound quality will
suffer.
Depress the connector terminal lever and run the cable
end into the corresponding opening.
Releasing the lever locks the cable end in
place.
Antennas
Danger
Risk associated with lightning strike!
If you are using outdoor or roof antennas, be
absolutely sure that the antenna has lightning
protection.
22
23
FM antenna
Connect the FM antenna to the jack 23 “FM ANT”. This
may be a roof/outside antenna, but also a cable televi-
sion connection. You will need a coaxial connector cable
for this.
If no antenna connection is available at the installation
location, you can use the enclosed throw-out aerial
햹.
Insert the antenna plug in the jack 23 “FM ANT” and
adjust the position of the throw-out aerial for best recep-
tion. Then fi x the antenna in place with adhesive tape or
a nail.
AM antenna
The enclosed antenna
햸 receives medium wave (AM)
stations. You can set up this antenna to be free standing
or screw it onto a (cabinet) wall.
햸
Connect the antenna’s connector cable with the jacks 22
“AM ANT” on the back side of the receiver. Depress the
connector terminal lever and run the cable end into the
opening. Releasing the lever locks the cable in place.