Installation Guide

Tetra
®
EdgeLine Cuttable Light Bar Installation Guide
8
To Unmate Connectors
Electrical Connections
Mate the male and female connectors of
each adjacent light bar while ensuring the
connectors are oriented in the same direction.
DO NOT attempt to mate upside down or
otherwise exert excessive force on the light
bar connectors. Be sure that the retaining clip
of the connectors are fully engaged and locked
together as indicated by a click. Attach jumper
cables as needed to work around any obstacles,
corners or separations. DO NOT pull on the
wires when un-mating the connectors.
Connect the leader cable to the rst light bar in
the run closest to the power supply.
Install an end cap into the open connector on
the last light bar in the series.
NOTE: If using leader cable with male connector
(GE-LC24IN-66M), connect driver and light bar
right side female connector, ip the end cap
around and install it into into the open male
connector on the last light bar in the series.
1
3
2
Last light bar
First light bar
Leader cable
• Pushing the plug latch, grasp the connector
at each end and pull apart.
• DO NOT pull on the wires when unmating
the connectors.
Pull direction
Push here