Installation Guide

Tetra

EdgeLine Cuttable Light Bar Installation Guide

WARNING / AVERTISSEMENT

Failure to strictly follow these instructions may subject the installer or others to personal injury. Failure to strictly follow these

instructions will also void the manufacturer’s warranties and may cause risk of re, product damage, damage to property, and injury

to persons. Please read all warnings contained below and follow all instructions carefully.

Le non-respect des instructions peut exposer l’installateur ou d’autres personnes à des blessures corporelles. Ce non-respect des

instructions annule également les garanties du fabricant et peut entraîner des risques d’incendie, d’endommagement du produit,

de dommages des matériaux ou de blessures corporelles. Veuillez lire attentivement l’ensemble des recommandations ci-dessous et

appliquer méthodiquement toutes les instructions.

Field Cuts

Gather materials: Seal gasket and cap,

conformal coating, electrical grade silicone,

sandpaper, cloth.

Clean debris from extrusion cut end with the

sandpaper and avoid sanding the edge of the

LED board.

If it is necessary to cut the lightbar for a better

t, the cutting resolution is 3 inches (76.2 mm).

Cut the lightbar as necessary to t the application.

Only cut the PCBA from the back to the front.

DO NOT cut from the LED side to the back.

NOTE: Perpendicular cuts ONLY. No angled cuts.

Pull out the LED board gently and clean and

deburr the cut end with a cloth or other

appropriate tool. Be careful not to damage the

dielectric, and to ensure no copper from the

trace is making contact with the PCB assembly

substrate. Finally, shake or blow out any dust

and debris from the extrusion.

Cut and discard

the end with the

female connector

CONFORMAL

COATING