Installation Guide
Tetra
®
EdgeLine Cuttable Light Bar Installation Guide
3
Components and Tools Required
1
2
3
4
5
6 7 8 9
10
Tetra
®
EdgeLine Cuttable Light Bar
Jumper cable with male and female connector
Leader cable with female connector
Leader cable with male connector
Mounting clips (88818 – standard), or (10734 – slim)
#10 (M5) self-tapping athead screws
UL approved 22-18 AWG (0.33-0.82 mm2) connectors or in-line/IDC connectors
UL approved 18 AWG (0.82 mm2) supply wire
24 Volt Power Supply
Connector sealing cover
Seal Gasket and Cap
Electrical grade silicone.
Examples of electrical grade silicone:
• Momentive RTV 6702 (white) / RTV 6708 (clear) - Silicone Rubber Adhesive Sealant
• Momentive RTV 162 (White) - Silicone Rubber Adhesive Sealant-Electrical Grade
• Dow Corning 3140 (clear) - Non-Corrosive Flowable
• Dow Corning 3145 (clear or gray) - Non-Corrosive Non-owable
• Dow Corning RTV 748 (white) - Non-Corrosive Sealant
Brush Conformal Coat such as the following:
• MG Chemicals 419D
• Humiseal 1B73, or
• Electrolube APL
12
13
11 12 13
1
2
3
4
5
6
7
8
9
10
11
Tc