Installation Guide

5
●Use plug
After hanging the mirror, insert the plug directly into the standard socket.
4. Connect the power. You can use the plug directly or connect the wire
to a standard switch lighting circuit.
DANGER: Before installation, make sure the
main power is cut off.
●Installation hardwired
Cut the plug and connect the mirror's wire to the power by the wire
connectors.
Thickness of wall ＞ 16mm ( 1/4" (6mm) drill bit, drilling depth in 131/32"(50mm) )
Thickness of wall ＜ 8mm
Unapplicable
( 25/64" (10mm) drill bit )
Thickness of wall 8 ~ 16mm
3. Use an electric drill to punch holes at the marked spots, and then
apply wall anchors with hammer.
Note: Please wear goggles and pay attention to safety.
!
4
3
Screw the two brackets on wall.
6
----------------------
5.Place the mirror against the wall, align the hook with the bracket slot,
slowly lower it so that the hook fits into the slot, and gently shake the
mirror to ensure that the mirror is securely installed.
Note: Two-person installation.
!
Completion !
BLACK WIRE --- POWER SUPPLY L (LIVE)
WHITE WIRE --- POWER SUPPLY N (NEUTRAL)
GREEN WIRE --- POWER SUPPLY E (EARTH)
WARNING: This mirror must be earthed.