Installation Guide

43
Electric Drill Hammer Marker Pen Tape Measure
Safety GogglesPhillips Screwdriver
Level
② The middle button is the color temperature touch.
The first touch is white light, the second touch is yellow light, the third
touch is natural light, and so on. Press and hold it to infinitely adjust the
color temperature.
-----------------
-------------------
-------------------
---------------------- ----------------------
Anti-fog touch
Color temperature touch
Light touch
③ The right button is the light touch.
The first touch is to turn on all the lights, the second touch is to turn on
only the front lights, the third touch is to turn on only the back lights,
and the touch again turns off all the lights, and so on. Press and hold it to
infinitely adjust the brightness.
If no button is pressed within 15 seconds, pressing again will turn the
light off immediately.
Memory Function : The current setting of the mirror will be saved. When
you turn on the mirror next time, it will be in the same settings as it was.
!
!
Note:Before installation, please confirm the position of the
mirror hanging hole.
The first line is the hole position distance.Before punching, please
confirm that the hole position of the positioning ruler is consistent
with the hanging hole of the product.
The second line is the product size.Find the position of the corre-
sponding hole according to the product width of the selected sus-
pension mode.
Choose the hanging method according to your preference, use the
positioning ruler to confirm the position of the hanging hole, make
sure it is horizontal, and use a marker to mark the hole positions
①②③④ on the wall.
Note:Please keep the proper distance from the mirror to the
faucet .
!
!
4
3
4
3
0
Corresponding
Holes for
Bracket:
Product Size:
2
7
16
"(62mm)
0 (Where you fix
the first bracket)
20" 22"/24"
11
9
16
"(293.6mm) 14"(355.6mm)9
1
8
"(231.6mm)
Positioning Ruler
Before installation, please
confirm where to drill holes
for hanging the mirror.