Installation Guide

Installation Instruction

Installation Tools

Level

Pencil Hammer

Safety Goggles

Electric Drill

Phillips Screwdriver Tape Measure

Mounting point measurement

Measure the distance of four hooks centre and use the level ruler

to draw a horizontal line on the wall and then mark the location

of the center of hooks.

The holes # 1 2 are used when installing the mirror horizontally.

The holes # 3 4 are used when installing the mirror vertically.

It is recommended to use only two hooks.

1 2

INSTALLATION OF MIRROR

PAGE 1
Installation Instruction Installation Tools Level Pencil Hammer Safety Goggles Electric Drill Phillips Screwdriver Tape Measure INSTALLATION OF MIRROR Mounting point measurement 3 1 2 4 Measure the distance of four hooks centre and use the level ruler to draw a horizontal line on the wall and then mark the location of the center of hooks. The holes # 1 2 are used when installing the mirror horizontally. The holes # 3 4 are used when installing the mirror vertically.
PAGE 2
Drill pilot holes on the marked spots -- -------- - ----- --- -------- ----BOMB Use an electric drill to punch two 6mm holes at the marked spots, and then apply wall anchors with hammer. (6mm drill bit, drilling depth in 5 cm) Insert the screw 7m m Use the screwdriver to loosen the screw on the wall anchors, set aside 7mm distance to wall.