User Manual

6 Using the product
48
> [Options] → Number of lines: change the number of
measured values per display page.
> [Options] → Recalibrate: the gas sensors are set to zero.
> [Options] → Measurement view: (This function is not available
during a measurement): the measured value display menu is
opened.
Showing the flue gas matrix
This function is only available if the measurement parameter CO
has been activated in the measured value display.
Call up function:
✓ The flue gas function is open.
> [Options] → Fluegas matrix.
Options
> [Options] → Clipboard: data is saved to the clipboard.
> [Options] → Delete clipboard: any data saved to the clipboard
is deleted.
> [Options] → Save: the measured values are saved in a record.
> [Options] → Show numeric value: data is displayed as
numerical values.
> [Options] → System type: (This function is not available
during a measurement) Set the system type to be able to
configure the ideal zone (green) of the flue gas matrix, using the
limits pre-configured for each system type.
> [Options] → Reset graphic: the displayed graphical values are
deleted.
> [Options] → Thresholds: (This function is not available during
a measurement) Enter limits to be able to configure the ideal
zone (green) of the flue gas matrix.
> [Options] → CO + O2 or CO + CO2: choose which parameter
should be assigned to the x-axis of the display matrix (O2 or
CO2).
> [Options] → Measurement view: (This function is not available
during a measurement) Open the measured value display
menu.
Pos: 83 /TD/Produkt ver wenden/testo 320/tes to 320_Zugmessung @ 11\mod_ 1327410556665_79. docx @ 105055 @ 355 @ 1
3.