User Manual

6 Using the product
38
Calling up the function:
> [ ] → Device settings → [OK] → Measurement view →
[OK]
Changing the parameter/unit in a line:
1. Select the line: [▲], [▼] → [Edit]
2. Select the parameter: [▲], [▼] → [OK]
3. Select the unit: [▲], [▼] → [OK]
4. Save changes: [OK]
Options:
> [Options] → Number of lines: change the number of
measured values per display page.
> [Options] → Blank line: insert a blank line in front of the
selected line.
> [Options] → Delete line: delete the selected line.
> [Options] → Factory setting: reset the measured value
display to the factory settings.
Pos: 64 /TD/Produkt ver wenden/testo 330/tes to 330 Alarschwellen @ 6\mo d_1279021018511_79. docx @ 65490 @ 45 @ 1
6.1.2.2. Alarm limits
Alarm limits can be set for several display parameters. An audible
alarm signal is triggered when the alarm limit is reached.
Calling up the function:
> [ ] → Instrument Settings → [OK] → Alarm Limits → [OK]
Switching alarm signals on / off, changing alarm limits:
1. Select function or parameter: [▲], [▼] → [Edit].
2. Set parameter: [▲], [▼] and partly [◄], [►] → [OK].
3. Save changes: [Finished].
> Reset the enabled value to the factory setting: [Standard].
Pos: 65 /TD/Produkt ver wenden/testo 320/tes to 320 Einheiten @ 11\mod_13 27407419025_79.doc x @ 104791 @ 45 @ 1
6.1.2.3. Units
The units used for parameters in configuration menus can be set.
Call up function:
> [ ] → Device settings → [OK] → Units → [OK].