User Manual

5 First steps
32
5.2.7. Saving data to the clipboard (temporary memory)
Using the clipboard, measurement results from various
measurement types can be combined to produce a common
record, which can then be printed out (see above). Data is saved to
the clipboard via the Options menu and the Clipboard command.
If there is data in the clipboard, the status bar shows the symbol .
If there is data in the clipboard and the Print command is triggered,
all data in the clipboard will be printed out.
> [Options] → Delete clipboard: Any data saved to the
clipboard is deleted.
5.2.8. Confirming an error message
If an error occurs, an error message is shown on the display.
> Confirming an error message: [OK].
Errors that have occurred but have not yet been rectified are
indicated by a warning symbol ( ) in the header.
Error messages that have not yet been cancelled can be displayed
in the Error diagnosis menu, see Instrument diagnosis, page 35.
5.2.9. Switching off
Unsaved measured values are lost if the flue gas analyser
is switched off.
> Press [ ].
- Depending on the instrument status, the pump starts and the
sensors are rinsed until the switch-off thresholds (O
2
> 20 %,
other measurement parameters < 50 ppm) are reached. Rinsing
lasts no more than 3 minutes.
- The measuring instrument switches off.
Pos: 55 /TD/Erste Sc hritte/testo 330/test o 330 Produkt kennenlerne n Ordner_Messorte @ 6\mod_12 78942335615_79.doc x @ 65332 @ 255553535 @ 1
5.3. Address/Location
All measuring values can be saved under the currently active
location. Measuring values that have not been saved are lost when
the measuring instrument is switched off!
Addresses and locations can be created, edited, copied and
enabled. Addresses and locations (incl. protocols) can be deleted.
Call up function:
> [ ] → Address/Location → [OK].
There are various options for opening address.
1. Edit search setting: [Edit].