testo 330i · Flue gas measuring instrument testo 330i LX · Flue gas measuring instrument Startup & Safety
Register your Testo product at www.testo.com/register and receive a one-year free warranty extension. The product registration is valid for 30 days after purchase. For product registration terms and conditions and participating countries, please go to www.testo.
1 Commissioning 1 Commissioning 1.1. Installing the App 1.2. Establishing a connection A mobile terminal device (tablet or smartphone) with the Android or iOS operating system and Bluetooth® interface is required to operate the testo 330i / testo 330i LX measuring instrument. The testo 330i App also needs to be installed on this mobile device: 1. Open the AppStore on the mobile terminal device. 2. Enter the search term Testo SE to start searching. 3. Select the testo 330i App and install.
1 Commissioning The Country version configuration affects the measurement parameters, fuels, fuel parameters, and the basis of and formulas for calculations activated in the measurement box. 4. Tap the Country version to be activated. 5. Tap Continue to perform a restart. 6. Restart the testo 330i App. 7. Tap instrument designation to select a measuring instrument. - The Flue gas function opens. - The instrument is operational. 1.3.
2 Safety and the environment 2 Safety and the environment Use > Please read this documentation through carefully and familiarize yourself with the product before putting it to use. Pay particular attention to the safety instructions and warning advice in order to prevent injuries and damage to the products. > Keep this document to hand so that you can refer to it when necessary. > Hand this documentation on to any subsequent users of the product. 2.1.
2 Safety and the environment Please note when emptying condensate: CAUTION Condensate entering the gas path. Damage to sensors and flue gas pump! > Do not empty the condensate container while the flue gas pump is in operation. Safety related symbols on the instrument Representation Explanation If the product is not used in strict compliance with this documentation, the intended protection may be impaired. > Operate the product only as described in this documentation.
2 Safety and the environment > Temperatures given on probes/sensors relate only to the measuring range of the sensors. Do not expose handles and feed lines to any temperatures in excess of 70 °C unless they are expressly permitted for higher temperatures. > The testo 330 must be checked before commissioning for any visible damage. Do not commission the testo 330 if there are signs of damage on the housing, mains unit or supply lines. Electrical risk.
2 Safety and the environment > At the end of its useful life, send the product to the separate collection for electric and electronic devices (observe local regulations) or return the product to Testo for disposal. > The button cell used in the instrument contains 1,2Dimethoxyethane (CAS 110-71-4). See EC Regulation No. 1907/2006 (REACH) Art. 33. > 8 WEEE Reg. no.
Testo SE & Co. KGaA Testo-Straße 1, 79853 Lenzkirch Telefon: +49 7653 681-0 Fax: +49 7653 681-100 E-Mail: info@testo.de Internet: www.testo.
