User's Manual
Table Of Contents
- user manual
- 1 Contents
- 2 Safety and the environment
- 3 Specifications
- 4 Product description
- 5 First steps
- 6 Using the product
- 7 Maintaining the product
- 8 Tips and assistance
- FCC说明书 RF警语
6 Using the product
17
6.3. Volume flow measurement setup
Standard hood
(610x610 mm, scope of delivery; 360x360, accessories)
1. Pull the lower end of the hood over the measurement base.
2. Attach the hood at two corners using the snap fasteners.
3. Tighten the closure.
4. Push the support rods through the hood, along the markings
and into the funnel in the measurement base.
5. Push the support rods on the top of the hood into the brackets.
- The hood is installed.