Instructions

10. Specifications
TT-SI 9010A
Bandwidth DC to 70MHz (-3dB)
Attenuation Ratio 1:100 / 1:1000
DC-Accuracy ±2%
Rise Time 5ns
Input Impedance
50M Ω // 10pF each side to ground
Input Voltage
- Differential Range
1:100 ±700V (DC+peak AC) or 500Vrms
1:1000 ±7000V (DC+peak AC)
or 5000Vrms
Input Voltage
- Common Mode Range
1:100 and 1:1000
±7000V (DC+peak AC) or 5000Vrms
Input Voltage
- Absolute Max.
(Differential or Common Mode)
1:100 and 1:1000
±7000V (DC+peak AC)
or 5000Vrms
Measurement Category CAT I
Output Voltage
- Swing
±7V (into 50k Ω load)
Output Voltage
- Offset (typical)
<±5mV
Output Voltage
- Noise (typical)
0,9mVrms
Source Impedance (typical) 50Ω (for using 1MΩ input system oscilloscope)
CMRR (typical) -80dB @50Hz, -60dB @20kHz
Ambient Operating
Temperature
-10°C to 40°C
Ambient Storage Temperature
-30°C to 70°C
Ambient Operating Humidity
25% to 85% RH
Ambient Storage Humidity
25% to 85% RH
Power Requirements
- Standard
4 x AA Cells
Power Requirements
- Optional
Power lead or Mains Adapter
(6VDC/60mA or regulated 9VDC/40mA)
Length of BNC Cable
90cm
Length of Input Leads
60cm
Weight 500g
Dimensions (LxWxH) 202mm x 83mm x 38mm
a. The supplied voltage must be less than 12V and greater than 4.4V, otherwise the probe
could be damaged or can’t be operated properly.
b. Polarity is “+” inside and “–” outside. For wrong polarity, built-in circuit protects the
probe, no danger or damage will occur.
c. When the voltage of the cells become too low, the power indicator on the will flicker.