Datasheet

Aktive Differential-Tastköpfe / Active Differential Probes
TT-SI 9010, TT-SI 9020
TT-SI 9010 TT-SI 9020
Ordernumber 15106 15107
Bandwidth
DC to 70MHz (-3dB) DC to 70MHz (-3dB)
Attenuation Ratio
1:100 / 1:1000 1:200 / 1:2000
Accuracy
±2% ±2%
Rise Time
5ns 5ns
Input Impedance
10MΩ // 10pF each side to ground 10MΩ // 10pF each side to ground
Input Voltage
– Differential Range
– Common Mode Range
– Absolute max. Voltage
CAT II in Differential Mode
– Absolute max. Voltage
CAT II in Common Mode
1:100 ±700V (DC + peak AC) or 700Vrms
1:1000 ±7000V (DC + peak AC) or 5000Vrms
1:100 ±7000V (DC + peak AC) or 2500Vrms
1:1000 ±7000V (DC + peak AC) or 2500Vrms
1:100 ±7000V (DC + peak AC) or 5000Vrms
1:1000 ±7000V (DC + peak AC) or 5000Vrms
1:100 ±7000V (DC + peak AC) or 2500Vrms
1:1000 ±7000V (DC + peak AC) or 2500Vrms
1:200 ±1400V (DC + peak AC) or 1400Vrms
1:2000 ±14000V (DC + peak AC) or 5000Vrms
1:200 ±7000V (DC + peak AC) or 2500Vrms
1:2000 ±7000V (DC + peak AC) or 2500Vrms
1:200 ±14000V (DC + peak AC) or 5000Vrms
1:2000 ±14000V (DC + peak AC) or 5000Vrms
1:200 ±14000V (DC + peak AC) or 2500Vrms
1:2000 ±14000V (DC + peak AC) or 2500Vrms
Output
- Swing
– Offset (typical)
– Noise (typical)
– Source Impedance (typical)
±7V (into 50kΩ load)
<±5mV
0,9mVrms
50Ω
±7V (into 50kΩ load)
<±5mV
0,9mVrms
50Ω
CMRR (typical)
-80dB @ 50Hz, -60dB @ 20kHz -80dB @ 50Hz, -60dB @ 20kHz
Power requirements: 4 x AA Cells or Mains Adaptor 6VDC/200mA or regulated 9VDC/120mA
Dimensions: (L x W x H) 202mm x 83mm x 38mm
Length: BNC Cable 90cm - Input Leads 60cm
Weight: 500g (including 4 cells)
Type
Specifi cations
Technische Änderungen vorbehalten / All specifi cations and characteristics are subject to change without notice