Datasheet

TT-HF 612

10:1 Miniature Probe

FOR MORE INFORMATION VISIT www.testec.de

IEC61010-031:2015

Attenuation Ratio: 10:1 ± 1% (@ DC)

Max. Input Voltage: Measurement Category I: 500 Vrms,

1500 V transient overvoltage (see voltage derating curve)

Measurement Category II: 400 Vrms

Pollution Degree: 2

All speciﬁcations are subject to change without notice!

Attenuation

Input

Impedance

Bandwidth

Rise

Time

Cable

Length

Compensation

Ratio

10:1

10 MΩ II 10 pF

DC to 500 MHz <0,7 ns

1,3 m 10…20 pF

Speciﬁcations

PAGE 1
TT-HF 612 10:1 Miniature Probe Specifications Attenuation Input Impedance Bandwidth Rise Time Cable Length Compensation Ratio 10:1 10 MΩ II 10 pF DC to 500 MHz <0,7 ns 1,3 m 10…20 pF Attenuation Ratio: 10:1 ± 1% (@ DC) Max. Input Voltage: Measurement Category I: 500 Vrms, 1500 V transient overvoltage (see voltage derating curve) Measurement Category II: 400 Vrms Pollution Degree: 2 All specifications are subject to change without notice! For more information visit www.testec.
PAGE 2
Probe Compensation Proper compensation of the probe is required to assure amplitude accuracy of the waveform being measured by matching the probe to the oscilloscope’s input capacitance. Compensation should be adjusted whenever the probe is connected to or transferred between oscilloscopes. Low Frequency Adjustment Apply a 1 kHz square wave to the probe or connect to the oscilloscope’s calibrator output.