Hardware Manual

39 / 48
TESSERA TECHNOLOGY INC.
4.4.3. SCI boot mode settings (via E2 emulator)
Connect the E2 emulator to the connector for the emulator (CN 1). Switch settings be
selected as shown in Table 4-6 and are typically used in power operating mode.
Table 4-6: SWD Mode (via Emulator) Switch Settings (Table)
reference
establishment
reference
establishment
SW3
Boot（SCI boot mode）
JP1
Close
SW4
-（Don’t care）
JP2
Close
JP3
Close
JP4
Open
JP5
Open
JP7
1-2（Normal mode）
JP8
1-2（Normal mode）
JP9
1-2（Normal mode）
JP10
Don’t care
JP11
Don’t care
JP12
Open
JP13
Open
RFP connection If the connection cannot be made using the normal procedure, please
follow the steps below.
1. Make the connection as shown in Table 4-6, Figure 4-5, Connect the emulator
connector (CN4) of the EB-RE01B board to the PC with an emulator.
2. start RFP on the PC. 3.
3. go to File > Create New Project, select Microcontroller as RE, name the project and
select "E2 emulator" in Tools. Make sure that 3.3V is selected in the tool details. See
Figure 4-6.
4. select "Connect" on the RFP.
5. the RFP will show "Operation successful. is displayed on the RFP.
6. select the program file to be written.
7. Press the "Start" button on the RFP.
8. When the RFP has completed writing, the message "Operation successful. is
displayed on the RFP.