Hardware Manual

37 / 48

TESSERA TECHNOLOGY INC.

Table 4-5: SCI boot (via USB) Jumper Pin Switch Settings (Table)

reference

Establishment

reference

establishment

SW3

Boot（SCI boot mode）

JP1

SW4

-（Don’t care）

JP2

JP3

JP4

2-3 Regulator Out

JP5

1-2（USB）

JP7

1-2（Normal mode）

JP8

1-2（Normal mode）

JP9

1-2（Normal mode）

JP10

1-2（RFP）

JP11

1-2（RFP）

JP12

Open

JP13

RFP connection If connection is not possible using the normal procedure, please follow

the steps below.

1. make the connections in Table 4 5. Connect the USB port (CN4) of the EB-RE01B

board to the PC with a USB cable. (Power will be supplied via USB).

2. start RFP on the PC.

3. go to File > Create New Project, select Microcontroller as RE, name the project and

make sure that "USB Serial Port" is selected in Tools.

4. press SW1 on the EB-RE01B board once. (Board reset)

5. select "Connect" on the RFP. 6.

6. the RFP will display "Operation successful." is displayed on the RFP.

7. Press SW1 on the EB-RE01B board once. (Board reset)

8. select the program file to be written.

9. Press the "Start" button on the RFP.

10. When writing is completed on the RFP, the message "Operation successful. is

displayed on the RFP.