Hardware Manual

10 / 48
TESSERA TECHNOLOGY INC.
1.5. Factory pin settings
The component layout of the EB-RE01B board as shipped from the factory is shown in
Figure 1-4 and the configuration in Table 1-2.
Figure 1-4 Factory Part Placement and Settings (Board)
Table 1-2 : Factory Part Placement and Settings (Table)
Reference
function
Settings
SW3
Operating mode settings
S_Chip
Single Chip Mode
SW4
Operating mode settings
Normal
Normal operation
JP1
Operating mode settings
Close
Normal operation
JP2
MCU power line
Close
Power applied
JP3
BLE Power Line
Close
Power applied
JP4
Operating mode settings
2-3 short
Regulator Out
JP5
Operating mode settings
1-2 short
USB
JP7
Operating mode settings
1-2 short
Normal operation
JP8
Operating mode settings
1-2 short
Normal operation
JP9
Operating mode settings
1-2 short
Normal operation
JP10
RFP/UART switching
2-3 short
UART settings
JP11
RFP/UART switching
2-3 short
UART settings
JP12
UART CTS/RTS Switching
Open
Not set
JP13
Operating mode settings
Close
UART available