Safety data sheet

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revised on / Version: 15.12.2014 / 0003
Replaces revision of / Version: 11.01.2013 / 0002
Valid from: 15.12.2014
PDF print date: 16.12.2014
26015 TESLANOL RB Rostlöser-Spray 200 ml
In the case of mixtures, the resistance of glove materials cannot be predicted and must therefore be tested before use.
The exact breakthrough time of the glove material can be requested from the protective glove manufacturer and must be observed.
8.2.3 Environmental exposure controls
No information available at present.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Physical state: Aerosol, Substance: Liquid
Colour: Yellow
Odour: Characteristic
Odour threshold: Not determined
pH-value: Not determined
Melting point/freezing point: Not determined
Initial boiling point and boiling range: -44 °C
Flash point: n.a.
Evaporation rate: Not determined
Flammability (solid, gas): Not determined
Lower explosive limit: 0,6 Vol-% (20°C, 2,5 - 4,5 bar )
Upper explosive limit: 8,5 Vol-% (20°C, 2,5 - 4,5 bar )
Vapour pressure: Not determined
Vapour density (air = 1): Not determined
Density: 0,68 g/ml (20°C)
Bulk density: Not determined
Solubility(ies): Not determined
Water solubility: Not determined
Partition coefficient (n-octanol/water): Not determined
Auto-ignition temperature: 240 °C (Ignition temperature )
Decomposition temperature: Not determined
Viscosity: Not determined
Explosive properties: Possible build up of explosive/highly flammable vapour/air
mixture.
Oxidising properties: Not determined
9.2 Other information
Miscibility: Not determined
Fat solubility / solvent: Not determined
Conductivity: Not determined
Surface tension: Not determined
Solvents content: ~54 %
SECTION 10: Stability and reactivity
10.1 Reactivity
See also Subsection 10.2 to 10.6.
The product has not been tested.
10.2 Chemical stability
See also Subsection 10.1 to 10.6.
Stable with proper storage and handling.
10.3 Possibility of hazardous reactions
See also Subsection 10.1 to 10.6.
Possible build up of explosive/highly flammable vapour/air mixture.
10.4 Conditions to avoid
See also section 7.
Heating, open flame, ignition sources
Pressure increase will result in danger of bursting.
10.5 Incompatible materials
Avoid contact with strong oxidizing agents.
10.6 Hazardous decomposition products
See also Subsection 10.1 to 10.5.
No decomposition when used as directed.
SECTION 11: Toxicological information
Page 6 of 13