User Manual
Table Of Contents
- Sill Outer (Front Section)
- Parts List
- Repair Information
- Prerequisites
- Removal
- Replacement
- Prepare the new Sill Outer front section.
- Create a reinforcement plate for the new Sill Outer front section.
- Prepare for installation of the new Sill Outer front section.
- Prepare the surfaces to install the new Sill Outer front section.
- Apply structural adhesive to install the new Sill Outer front section.
- Install the new Sill Outer front section.
- Prepare a backing plate for the installation of the new Hinge Pillar se
- Prepare for installation of the new Hinge Pillar section.
- Prepare the surfaces to install the new Hinge Pillar Assembly section.
- Apply structural adhesive to install the new Hinge Pillar Assembly sect
- Install the new Hinge Pillar Assembly section.
- Prime any bare metal that will not be covered with weld-through primer
- Prepare the new Body Side Outer section for installation.
- Create and install backing plates for the Body Side Outer butt joints.
- Prepare for the installation of the new Body Side Outer section.
- Prepare the surfaces to install the new Body Side Outer Section.
- Apply structural adhesive to install the new Body Side Outer section.
- Install the new Body Side Outer section.
- GMA weld the Body Side Outer butt joints.
- Secure the butt joint flanges.
- If required, apply a suitable body filler to the joints and finish for
- Prime any bare metal with a suitable corrosion-resistant epoxy primer.
- Seal the seams in the factory locations, and as necessa
- After refinishing, use a 360-degree spray wand of suitable length to ap
- Install the new Shotgun Outer.
11
Install the new Hinge Pillar Assembly section (continued).
I
P
erform resistance spot welding to install the new Hinge Pillar
Assembly section and A-Pillar to Shotgun Reinforcement
(continued).
Sill Outer (Front Section)
Replacement
TESLA BODY REPAIR MANUAL
F
or feedback on the accuracy of this document, email BodyRepair@tesla.com.
Updated: 09APR18 87