User Manual

Repair Information Warnings and Cautions Special Tools
If the damage extends beyond the
specified cut line in the "Removal"
section of this document, discontinue
this procedure and perform the Front
Frame Rail Inner (Large Front Section)
procedure.
This procedure is for the left-hand
component; the procedure is identical for
the right-hand component.
The items listed in the "Prerequisites"
section of this document include only the
last structural component that needs to
be removed before starting the repair
and any other prerequisites that are not
obvious. Refer to the estimating system
being used for a complete list of the
prerequisites that must be performed
before starting the repair.
WARNING: Wear the appropriate
personal protective equipment
(PPE) when performing this
procedure.
CAUTION: This procedure involves
only steel components. Use the
appropriate tools to avoid cross-
contamination.
The special tools listed below are
required to perform this procedure:
• Resistance Spot Welder
Use only an approved resistance spot
welder. Refer to BR-16-92-007,
"Approved Welders" for a list of
current approved resistance spot
welders.
• GMA welder
Use only an approved GMA welder.
Refer to BR-16-92-007, "Approved
Welders" for a list of current approved
GMA welders.
• Frame bench
The vehicle must be properly mounted
on an approved frame bench to
replace this component. Refer to
BR-16-92-006, "Approved Frame
Bench Systems" for a list of current
approved bench repair systems.
Front Frame Rail Inner (Small Front Section)
Repair Information
TESLA BODY REPAIR MANUAL
For feedback on the accuracy of this document, email [e-mail].
Updated: 11MAY18 4