Certifications 2

Page 5/10
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 13.03.2019 Revision: 13.03.2019Version number 54
Trade name tesa 60022 Spray Glue EXTRA STRONG
(Contd. of page 4)
48.1.33
·
Further information about storage
conditions:
Keep container tightly sealed.
·
7.3 Specific end use(s)
No further relevant information available.
*
SECTION 8: Exposure controls/personal protection
·
Additional information about design
of technical systems:
No further data; see item 7.
·
8.1 Control parameters
·
Components with critical values that require monitoring at the workplace:
79-20-9 methyl acetate
WEL Short-term value: 770 mg/m³, 250 ppm
Long-term value: 616 mg/m³, 200 ppm
106-97-8 butane, pure
WEL Short-term value: 1810 mg/m³, 750 ppm
Long-term value: 1450 mg/m³, 600 ppm
Carc (if more than 0.1% of buta-1.3-diene)
141-78-6 ethyl acetate
WEL Short-term value: 1468 mg/m³, 400 ppm
Long-term value: 734 mg/m³, 200 ppm
110-82-7 cyclohexane
WEL Short-term value: 1050 mg/m³, 300 ppm
Long-term value: 350 mg/m³, 100 ppm
110-54-3 n-hexane
WEL Long-term value: 72 mg/m³, 20 ppm
·
Additional information:
The lists that were valid during the compilation were used as basis.
·
8.2 Exposure controls
·
Personal protective equipment
·
General protective and hygienic
measures
The usual precautionary measures should be adhered to in handling the
chemicals.
Keep away from foodstuffs, beverages and food.
Instantly remove any contaminated garments.
Wash hands before breaks and at the end of the work.
Avoid contact with the eyes and skin.
·
Breathing equipment:
Not necessary if room is well-ventilated.
Use breathing filter A2
In case of short term exposure use respiratory protection. In case of
intensive or longer exposure use respiratory protection equipment
independent from ambient air.
·
Protection of hands:
Solvent resistant gloves
Protective gloves.
The glove material has to be impermeable and resistant to the product/
the substance/ the preparation.
Selection of the glove material on consideration of the penetration
times, rates of diffusion and the degradation
·
Material of gloves
Nitrile rubber, NBR
use solvent stable gloves.
·
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the
protective gloves and has to be observed.
·
Eye protection:
Safety glasses
(Contd. on page 6)
GB