Certifications 2

Page 4/11
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 13.03.2019 Revision: 13.03.2019Version number 195
Trade name tesa 60020 60021 Spray Glue PERMANENT
(Contd. of page 3)
48.1.33
·
6.2 Environmental precautions:
Prevent product from reaching sewage system or water bodies.
Inform resposible authorities in case of spilling into water or sewage
system.
·
6.3 Methods and material for
containment and cleaning up:
Dispose of contaminated material as waste according to item 13.
Ensure adequate ventilation.
·
6.4 Reference to other sections
See Section 7 for information on safe handling
See Section 8 for information on personal protection equipment.
See Section 13 for information on disposal.
*
SECTION 7: Handling and storage
·
7.1 Precautions for safe handling
Keep away from heat and direct sunlight.
Ensure good ventilation/exhaustion at the workplace.
·
Information about protection
against explosions and fires:
Do not spray on flames or red-hot objects.
Keep ignition sources away - Do not smoke.
Beware: Container is pressurized. Keep away from direct sun exposure
and temperatures over 50°C. Do not open by force or throw into fire
even after use.
·
7.2 Conditions for safe storage, including any incompatibilities
·
Storage
·
Requirements to be met by
storerooms and containers:
Observe official regulations on storing packagings with pressurised containers.
Storage location and storage conditions must comply with the rules for handling
and storage of substances and preparations of the WGK 3. Any site-specific
regulatory requirements must be fulfilled.
·
Information about storage in one
common storage facility:
Not required.
·
Further information about storage
conditions:
Keep container tightly sealed.
·
Storage class
2B pressurized-gas packages
·
7.3 Specific end use(s)
No further relevant information available.
*
SECTION 8: Exposure controls/personal protection
·
Additional information about design
of technical systems:
No further data; see item 7.
·
8.1 Control parameters
·
Components with critical values that require monitoring at the workplace:
106-97-8 butane, pure
WEL Short-term value: 1810 mg/m³, 750 ppm
Long-term value: 1450 mg/m³, 600 ppm
Carc (if more than 0.1% of buta-1.3-diene)
·
Additional information:
The lists that were valid during the compilation were used as basis.
·
8.2 Exposure controls
·
Personal protective equipment
·
General protective and hygienic
measures
The usual precautionary measures should be adhered to in handling the
chemicals.
Keep away from foodstuffs, beverages and food.
(Contd. on page 5)
GB