Replacement Part List
SETUP INSTRUCTIONS
PACKING
STRAP
WEBBING
LOOP HANDLE
HUB
ROOF
4. Once all walls are popped open, locate the zipper door, and
enter the screen tent. Proceed to push up on the hub OR roof
poles until it pops over center. [ SEE FIGURE 4 ]
FIGURE 4
1. Remove the screen tent from the carrying bag. Stand the screen
tent up with the hub on the ground. Remove the packing strap
from around the top of the screen tent. [ SEE FIGURE 1 ]
FIGURE 1
2. Release the screen tent until it is unfolded and the roof is
exposed. DO NOT pop roof up yet. [ SEE FIGURE 2 ]
NOTE: When unfolding, check that the roof is visible and locate the
webbing loops located in center of wall panel. This is the OUTSIDE
portion of the screen tent. The poles and hubs are the INTERIOR of
the screen tent.
FIGURE 2
3. Find the webbing loop handle located on the exterior of each
hub, centered on each wall (and roof). Proceed to pull outward
until the wall pops open. Do this to all SIDE WALLS rst.
[ SEE FIGURE 3 ]
NOTE: For added assistance, grasp the top seam of the panel and
place your foot on the bottom edge when popping open a side
wall panel to help hold the screen tent in place.
FIGURE 3