Installation Guide

Table Of Contents

3-4

Chapter 3: Maintaining the IntelliVue Smart-hopping 1.4 GHz Core Access Point

• Remote Antenna - The Core AP provides two LEDs on each RJ-45 UTP cable

connector that provides status on a connected Remote Antenna:

- RA Connection - Lights GREEN to indicate a RA is connected to the Core AP.

- RA Power - Lights YELLOW to indicate connected RA is receiving power from

the Core AP.

If the Status LED indicators are not functioning properly as indicated then perform

the appropriate troubleshooting procedures. If you cannot resolve the problem with

the LEDs, then make written note of the LED lighting and sequence of colors,

replace the unit, and send the defective unit back to Philips with the explanation of

LEDs sequence and colors displayed. Refer to Chapter 4 of the IntelliVue Smart-

hopping Infrastructure Installation and Service Guide for complete AP replacement

procedures.

Troubleshooting the Remote Antenna Using its LEDs

Complete test and inspection procedures for the IntelliVue Smart-hopping 1.4 GHz

Remote Antenna are given in Chapter 5 of the IntelliVue Smart-hopping

Infrastructure Installation and Service Guide. You must perform these procedures

when the Remote Antenna is initially installed and after any service event.

Figure 3-2 shows the location of the IntelliVue Smart-hopping 1.4 GHz Remote

Antenna LEDs.

A summary of the Remote Antenna’s status LEDs is given below to help you

troubleshoot any operational problems that may arise.

• Remote Antenna - The Core AP provides two LEDs on each RJ-45 UTP cable

connector that provides status on a connected Remote Antenna:

Figure 3-2: IntelliVue Smart-hopping Remote Antenna LEDs

UTP Cable Connector

to Core AP

Connection LED

(Green)

Power LED

(Yellow)

ITS4846A Core AP Remote

Antenna