Installation Guide

Connectors and Status Indicators (ITS4834B and ITS4834C)
IntelliVue Smart-hopping 1.4 GHz Access Point Installation Guide 1-9
Connectors and Status Indicators (ITS4834B and ITS4834C)
Figure 1-4 shows the controls and connectors on the 1.4 GHz IntelliVue Smart-
hopping Core AP and Remote Antenna.
IntelliVue Smart-hopping Core AP Connectors
Note the following connectors on the IntelliVue Smart-hopping Core AP:
• Ethernet Interface - The AP provides a 100 Base-T Ethernet interface with an
RJ-45 connector to connect the Core AP to the IntelliVue Smart-hopping Sync
Unit.
The AP Ethernet interface provides data communications to and from the
IntelliVue Information Center over the IntelliVue Smart-hopping LAN
infrastructure. It also presents the 48Vdc power and synchronization signals
required by the Core AP. The synchronization signal is superimposed on the
power supply voltage. Attach the provided ferrite block to the CAT 5 cabling
(from the Sync Unit) no more than 20 inches (50 cm) from the RJ-45 connector
as shown in Figure 2-2 to reduce electromagnetic (radiation) interference.
Table 1-2 lists the pin signals for the AP Ethernet interface.
Figure 1-4: 1.4 GHz IntelliVue Smart-hopping Core AP and Remote Antenna Controls
and Connectors
Table 1-2: AP Ethernet Interface Pin Signals
Pin Signal Description
1 Transmit Pair TX + Conductor
2 Transmit Pair TX - Conductor
3 Receive Pair RX + Conductor
4 + 48Vdc Power and Synchronization
5 + 48Vdc Power and Synchronization
Ethernet Interface to
IntelliVue Smart-hopping
IntelliVue Smart-
hopping Core Access
IntelliVue Smart-hopping
Remote Antenna
Power/Sync, Radio,
and Network
Status LEDs
Serial Port
UTP Cable Connectors
to Remote Antennas (1 & 2)
with RA Status LEDs
Coaxial Cable Connector
to IntelliVue Smart-hopping
Core Access Point
Coaxial Cable Connectors
to Remote Antennas (1 & 2)
UTP Cable Connector
to IntelliVue Smart-hopping
Link LED
Activity LED
Connection LED
(Green)
Power LED
(Yellow)