Operation Manual
NOXON 
I'm playing a music file, but I can't hear anything. 
Either the NOXON is muted, or the volume is so low that you can't hear anything. Turn up the volume and/or 
press the Mute button. Ensure that the connected stereo or speaker system is powered up. In the case of 
DRM content, the digital output is disabled for legal reasons. 
The radio stream is interrupted suddenly. 
You may have a throughput problem with your Internet connection. Sometimes the problem is also with the 
station itself. Switch to a different station and try again. Also see the solutions in Appendix B. 
Playback stops abruptly. 
This may be due to a communication problem. It can be the result of radio interference, being out of range, 
or problems with your server or router. Reboot your system and try again. Also see the solutions in Appendix 
B. 
My computer/NOXON has found an unknown ad hoc network. 
An additional ad hoc network is in operation in your vicinity. Should you have problems with your configura-
tion, please ensure that the option to automatically connect with non-preferred networks is disabled in the 
network settings. Disable and re-enable your network connection. 
My computer cannot be found when switching from ad hoc to network mode (or back). 
Restart the music server and your NOXON. Your computer will then be recognized again. 
How can I make subsequent changes to my configurations? 
Press the network button 
 on your remote control to open the configuration menu, in which you can 
modify a wide range of settings. 
How should I proceed with a manual IP configuration? 
Press the “Network” button to open the configuration menu. Launch the wizard, select “Next” and select 
your access point as usual. The “Static IP address” option must be selected in the IP settings. In the next 
step, enter the IP address. Finish the setup with the proxy settings as usual and apply them. 
Can I check all of my settings? 
Yes, by selecting “Status” in the configuration menu. The full range of information and settings related to 
your current configuration is displayed here. 
I would like to set up another profile for a different location. Is that possible? 
Yes, the “Profile selection” item is located in the configuration menu. You can create three personal profiles 
here that will be stored in the NOXON and which can be selected whenever you need them. 
56 ENGLISH 










