Operation Manual

This will disappear with the following jet of steam. It is therefore not
recommended to point the first jet of steam directly onto the item to be
ironed.
The iron must be used and left at rest on a firm surface.
WARNING!
Always unplug the iron from the outlet before filling the boiler with
water.
WHEN YOU HAVE FINISHED IRONING
• Turn the selector (2) to the position;
• Press button (17) on the iron, until the boiler is completely empty
and no more steam is being produced;
• Turn the selector (2) to position to turn off the appliance.
• Unplug the appliance from the outlet;
• Rest the iron on the support base (7) and wait for the appliance to
completely cool down before putting it away.
NO MORE WATER WHILE IT IS BEING USED
• The jet of steam becomes less and finally disappears if there is no
more water. The “water end” (3) indicator goes on.
• Carefully follow the instructions given below to fill up the boiler
again:
- turn the selector (2) to the position;
- press button (17) on the iron, until the boiler is completely empty and
no more steam is being produced;
- turn the selector (2) to position to turn off the appliance;
- unplug the appliance from the outlet;
- slowly unscrew the boiler cap being careful of any eventual residual
steam;
- fill up the boiler following instructions given in the “HOW TO FILL
THE BOILER WITH WATER” paragraph;
- switch on the appliance again following the same instructions given
in the “STARTING UP” paragraph.
 ENGLISH