Operation Manual

 ENGLISH

PILOT LIGHT AND ON PUSH BUTTON

After fitting the nozzle and filling the tank with water, plug the appliance

into the power socket making sure the mains voltage corresponds to

the one shown in the data plate of the

appliance.

Press the on push button (7): pilot light (8)

turns on, indicating that the appliance is

working.

When the appliance reaches its working

temperature (after about 30 seconds), it

delivers steam.

Now the appliance can be used on the surface to be cleaned. Press

push button (7) at the end of use or in order to stop the steam delivery.

Pilot light (8) will turn off indicating that the appliance is off and the

steam jet will stop coming out from nozzle (11).

NOTE: When the appliance is running, the internal pump makes noise.

This is normal.

WARNING!

• After use and during the tank filling operation, switch off the appliance

and unplug it from the power socket.

• Pay attention not to enter in contact with steam and with the

hot surfaces of the appliance since they could cause burns.

• Do not use the appliance to clean waxed floors, leather

surfaces, synthetic materials, velvet or other material sensitive to

steam.

LACK OF WATER DURING OPERATION

If water in the tank runs out during use, the appliance becomes more

noisy and steam is not delivered. Should this occurr, turn the appliance

off by pressing push button (7): pilot light (8) turns off. Unplug the

appliance from the power socket and fill the tank following the instructions

shown in paragraph “TANK FILLING”.

STARTING UP

Fig.3