Operation Manual

30 |
 ENGLISH
Setting spool pins
The spool pins are used for holding the spool of
thread in order to feed thread to the machine.
To use, pull up the spool pin. Push down for storage.
➀ Upper thread
➁ Hole
➂ Tangle
NOTE: In case of using the thread which has tendency to
tangle around the spool pin, thread through the hole of spool
pin as shown. The hole should face to the thread spool.
Removing or inserting the bobbin case
Open the hook cover.
Raise the needle by turning the balance wheel toward you.
Take out the bobbin case by holding the latch.
When inserting the bobbin case, place the horn into the recess
of the hook race.
manuale inventa 200 A4 24-07-2008 14:28 Pagina 30