Operation Manual

 ENGLISH
Connecting Machine to Power Supply
➀ Power supply plug
➁ Power switch (I / 0)
➂ Outlet
➃ Machine socket
➄ Machine plug
Before connecting the power cord, make sure the
voltage and the frequency shown on the machine
conform to your electrical power.
1. Turn off the power switch.
2. Insert the machine plug into the machine socket.
3. Insert the power supply into the power outlet.
4. Turn on the power switch to turn on the power and
sewing light.
Caution:
This appliance has a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock,
this plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician. Do not
modify the plug in any way.
Reverse stitch sewing
Press down on the reverse sewing lever and the
machine will start sewing reverse.
Presser Foot Lifter
➀ Presser Foot Lifter
➁ Normal up position
➂ Highest position
The presser foot lifter raises and lowers the presser
foot.
You can raise it about 0.6 cm higher than the normal up
position for easy removal of the presser foot or to allow
you to place heavy fabric under the presser foot.
14 |
SECTION 1. NAMES OF PARTS
Names of Parts
Stitch selector
Bobbin winder stopper
Bobbin winder spindle
Bobbin winding tension disk
Thread take-up lever
Upper thread guide
Thread tension dial
Needle
Needle plate
Extension table
Presser foot
Reverse stitch control
Carrying handle
Spool pin
Handwheel
Power switch
Machine socket
Free-arm
Presser foot lifter
Standard Accessories
Bobbin
Seam ripper
Felt
Sliding buttonhole foot
Need Ie set
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
1
2
3
4
5
SECTION 2. GETTING READY TO SEW
manuale inventa100 A4 24-07-2008 12:47 Pagina 14