User Guide

7
V.1.0.R1.2022
4. ASSEMBLY
Place of installation
TERMA Inclusive Tracking Play Panel is designed to be installed in the playground. The safety zone shall
be defined around the equipment which is 150 cm from each edge of the device. The safety zone of the
Inclusive Tracking Play Panel cannot overlap the other devices safety zones and the traffic routes.
No shock-absorbing surface is not required around the TERMA Inclusive Tracking Play Panel, but a
wheelchair user must have an easy access.
Tools needed for assembly:
Spade 2 pieces
Rake 1 piece
Spirit level 0, 5 rm 1 piece
17 open-ended or socket wrench 1 piece
Measure 3m 1 piece
Chemical anchor Fischer FIS VL 410 C or Tytan EVOLUTION II 1 pack of 410 ml
Loctite 243 Adhesive 1 pack of 10 ml
Hammer drill with a drill fi 12 min drilling length 180mm
WARNING! The manufacturer does not provide any tools for assembly!
Two people are needed to assemble the TERMA Inclusive Tracking Play Panel.
To ensure the comfortable and safe access for wheelchair users the rigid surfaces
are To ensure the comfortable and safe access for wheelchair users the rigid
surfaces are recommended. Loose surfaces such as sand or crushed stone are
excluded, grass surfaces are not recommended.
It is forbidden to install the device in geologically unfavorable conditions, i.e. in a
boggy or loose ground causing subsidence of foundations or in a ground where
water appears after the excavation has been made. Geological conditions should
be regulated prior to installation (effective drainage).