INCLUSIVE TRACKING PLAY PANEL USER GUIDE V.1.0.
1. INTRODUCTION Thank you for choosing our product! We believe you would be satisfied using our Inclusive Tracking Play Panel. Inclusive Tracking Play Panel combines outdoor fun with therapy. Device aims to integrate non-disabled people and those with disabilities (using wheelchairs), giving them possibility of playing together. Besides inclusive purpose TERMA Inclusive Tracking Play Panel provides kinesiotherapy and social rehabilitation. The device complies with PN-EN 1176 standard.
2. DEVICE STRUCTURE Materials: Inclusive Tracking Play Panel is made of the following materials: Construction: steel profile with epoxy primer, powder coated Front: HDPE board, 12 mm thick Foundation: concrete class min.
Ground level Fig. Dimensions of the device 2 V.1.0.R1.
3 V.1.0.R1.
Inclusive Tracking Play Panel consists of the following elements: No Component 1 Main construction Quantity Figure [pcs.] 1 Foundation block 2 3 4 (optionally) Foundation pin M10x300 1 4 Nut M10 12 DIN EN ISO 4032 3. INSTALLATION To ensure the highest level of safety standards for users and caregivers, it is necessary to read and follow the steps of installation sequence, assembly quality and safety instructions below.
Ensure a comfortable and safe entry for wheelchair access to the device. No shock-absorbing surface is required around the TERMA Inclusive Tracking Play Panel. The rigid surfaces are recommended for wheelchair access. Loose surfaces such as sand or crushed stone are excluded, grass surfaces are not recommended. The surface around the device should also not allow the foundations of the structure to be exposed (e.g. no loose surface such as sand or gravel should be used).
The foundation block should be permanently attached to the ground. Foundations should be at a depth of min. 200 mm below the ground level. Ground level Ground level 6 V.1.0.R1.
4. ASSEMBLY Place of installation TERMA Inclusive Tracking Play Panel is designed to be installed in the playground. The safety zone shall be defined around the equipment which is 150 cm from each edge of the device. The safety zone of the Inclusive Tracking Play Panel cannot overlap the other devices safety zones and the traffic routes. No shock-absorbing surface is not required around the TERMA Inclusive Tracking Play Panel, but a wheelchair user must have an easy access.
Next steps of assembly: 1. Digging a hole for a concrete screed or a block 2. Placing the foundation and drilling holes for the pins 3. Placing the pins in the foundation 4. Installing the device on foundation pins 5. Filling the foundations 1. Digging the hole for a concrete screed or concrete block Tools: Shovel / spade Measure 3 meters There are two options for installing the device in the ground. Option 1: Dig holes according to the following drawings.
9 V.1.0.R1.
1. Placing the foundations and drilling holes for the pins No Component 1 Main construction Quantity Figure [pcs.
Install foundation pins in the holes according to the instructions of the chemical anchor manufacturer. The minimum length of the pin protruding from the foundation is shown in the drawing. Follow the setting time of the anchors according to the manufacturer's recommendations. The labyrinth should be attached to the foundations using washers and cap nuts. Before screwing in the nut, coat the thread with Loctite 243. When drilling, be especially careful not to damage the paint coating! Mounting plate 2.
3. Installing the device on foundation pins Start by threading two pieces of nuts onto each stud, as in the first picture below, with the top nut approximately 30mm above the foundation surface. 12 V.1.0.R1.
In the next step, place the main structure on the pins so that the foundation plate rests on the top nuts. Then, using a spirit level, level the device by adjusting its position with nuts so as to set the bearing column vertically. The last step is to fix the structure with locknuts. Use Loctite 243 glue before screwing them onto the pins. 13 V.1.0.R1.
5. FUNCTIONAL TESTS BEFORE COMMISSIONING THE DEVICE Before putting the device into use, check the following functionalities to confirm the safety of users and correct installation: - stability of the device mounting on the foundation, - smooth slide of the element. 6. MAINTENANCE, INSPECTION, REPAIRS It is recommended to keep a book of inspections of devices in accordance with PN-EN 1176 standard.
In the event of a failure of devices or any malfunctions in their operation, the devices should be secured against users until the damage is removed by fencing it with a construction signal tape with a suspended sign informing about the damage, for example: "WARNING DEVICE FAILURE". Contact the Manufacturer to explain the malfunction and take corrective actions . The principles of warranty repairs and service are described in this manual.
1 or 2 Fig. Location of the spare parts 7. HOW TO USE INCLUSIVE TRACKING PLAY PANEL The Inclusive Tracking Play Panel is dedicated for both non-disabled and disable (those with physical disabilities, using wheelchairs, with intellectual disability or disability causing limits in the upper limbs functions) users. The device is designed for users from 3 years of age.
WARNING! It is forbidden to climb over the device! WARNING! It is forbidden to overload the device! Before using the device, it is absolutely necessary to read this User Guide and follow the guidelines. TERMA Sp. z o.o. or a service designated by the manufacturer are the only entity that can perform repairs and inspections. The manufacturer is not responsible for modernization and repairs made by other entities.
8. WARRANTY Terma Sp. z o.o. guarantees good condition and efficient operation of the device mentioned in the Warranty Card, hereinafter referred to as Product, according to the technical and exploitation details described in the user guide. Warranty confirms the responsibility of the entity who introduced the product to the market to free of charge removal of any faults of the product that was sold.
6. The warranty excludes cases of random damage of the device and coating, independent of operating conditions (for example: thefts, accidents, fires, floods) and mechanical damage caused by improper use. 7. The Buyer, by submitting the Product to the Service, and in particular by sending it to third parties, shall provide him with a secure package. Any damage or damage to the Product resulting from its improper packaging shall be covered by the Buyer. 8.
15. Warranty does not cover parts and materials whose consumption is a natural consequence of work, and these are, in particular, consumable items that are clearly consumed during the operation of the Product. Warranty rights do not include the buyer's right to demand the return of the lost profits in connection with the failure and repair of the Product. 16. The manufacturer is not responsible for the quality of the installation of the device performed by an external entity.
9. INCIDENT APPLICATION FORM In the event of an incident that results in damage to the equipment or injury to the patient, manufacturer must be immediately reported. After filling the "Incident application form," given below, it should be provided to the manufacturer by e-mail termamed@termamed.pl or by Post Office service.
Consequences of the incident: Taken remedial measures: Additional information 22 V.1.0.R1.
