Operation and maintenance manual

SM 2122 Rev 1 4-02
3
Section 110-0050
Fig. 3 - Exploded View of Typical Air Cleaner
Engine - Air Cleaner
SM - 1263
1 - Access Cover
2 - Gasket
3 - Wing Nut
4 - Gasket
5 - Primary Filter Element
6- Nut
7 - Cotter Pin
8 - Secondary (Safety) Filter Element
9 - Latches
10 - Body
11 - Clamp
12 - Gasket
13 - Tube Section
14 - Clamp
15 - Dust Cup
16 - Vacuator Valve
17 - Inlet Cap
4. Slacken clamps (8 & 10) and slide hose (7) clear of
the air cleaner assembly.
5. Using suitable lifting equipment, support the air
cleaner assembly and remove bolts (2), washers (4),
lockwashers (3) and nuts (5). Remove air cleaner
assembly from brackets (1 & 13).
6. Blank off air cleaner outlet and hose (7) end with
tape or cardboard to prevent entry of dirt.
7. If required, remove bolts (2), washers (4),
lockwashers (3) and nuts (5) securing brackets (1 & 13)
to the right hand fender. Remove brackets (1 & 13).
Disassembly
Numbers in parentheses refer to Fig. 3.
1. Remove air cleaner access cover assembly by
undoing securing latches (9). Empty dust collected in
access cover (1) and wipe clean.