Operation and maintenance manual

1
Section 260-0010
SM 1404 Rev 1 10-03
Fig. 1 - Cab and Mounting
DESCRIPTION
Numbers in parentheses refer to Fig. 1.
The cab is fully insulated and mounted on rubber
isolation mounts (2) to damp structure-borne noise and
vibration. It conforms with ISO/SAE, ROPS (Roll Over
Protective Structure) and FOPS (Falling Object
Protective Structure) requirements as standard.
ROPS - ISO 3471, SAE J1040 APR 88
FOPS - ISO 3449, SAE J231
WARNING
The protection offered by the roll over and
falling object protective structure may be
impaired if it has been subjected to any
modification or damage.
Cab assembly (1) is spacious and offers outstanding
visibility through large areas of tinted safety glass.
Access to cab assembly (1) is from the left hand side
with open tread steps, platform and handrail.
The cab interior, trimmed with noise-absorbent
material, is extensively thermally insulated and a
heater/filter/pressurizer and demisting unit keeps
internal air fresh and dust free. Sliding windows provide
additional ventilation. A side mounted air conditioner is
also fitted. Refer to Section 260-0130, AIR
CONDITIONING.
Note: Access from the cab, in the case of an emergency,
can be gained by breaking any of the windows using the
hammer provided (mounted on the right hand cab pillar).
SM - 1841
CAB - Cab and Mounting
5- Bolt
6- Bolt
7 - Hardened Washer
8 - Rear Window Guard
9 - Spill Guard
10 - Support
11 - Bolt
12 - Lockwasher
1 - Cab Assembly
2 - Isolation Mount
3 - Washer
4 - Locknut
13 - Locknut
14 - Bolt
15 - Lockwasher
16 - Firewall Barrier Mat
4
7
2
3
5
1
16
6
3
2
4
15
14
8
11
12
13
9
10
FRONT MOUNTING
REAR MOUNTING