Operation and maintenance manual

Section 230-0081

Body System - Body Control Joystick

SM 1411 Rev 2 04-02

the 'Off' position.

3. Disconnect harness (3) from connector port on the

bottom of body control joystick (1).

4. Support body control joystick (1) and remove screws

(2) securing body control joystick (1) to mounting

bracket on the underside of the right hand dash panel.

5. Remove body control joystick (1) from mounting

location.

6. Secure new body control joystick (1) to mounting

bracket on the underside of the right hand dash panel

with screws (2).

Note: Ensure identifying mark on the body control joystick

casing is orientated towards the rear of the cab.

7. Reconnect harness (3) to connector port on the

bottom of the body control joystick (1).

8. Place the battery master switch in the 'On' position,

start the engine and bring hydraulic oil to operating

temperature. Operate the body control joystick (1) to

ensure correct operation.

9. Remove wheel blocks and place the steering lock

bar in the 'Stowed' position.

SPECIAL TOOLS

There are no special tools required for procedures

outlined in this section. Refer to Section 300-0070,

SERVICE TOOLS, for part numbers of general service

tools required. These tools are available from your

dealer.

* * * *