Operation and maintenance manual

Section 210-0060
Cooling System - Transmission Oil Cooler
SM 1922 Rev 2 11-04
2
SM - 2432
1. Position the vehicle in a level work area, apply the
parking brake and switch off the engine. Turn
steering wheel several times to relieve any pressure
in the steering circuit.
2. Block all road wheels and place the battery master
switch in the 'Off' position.
3. Pull on handle (inside cab) to release hood catch
and raise hood.
4. Open drain cock at the bottom of the radiator
assembly and drain coolant into a suitable container.
Close drain cock when coolant is completely drained.
5. Support engine sump guard with suitable blocking and
remove mounting hardware securing rear of sump guard
to the frame. Drop rear end of sump guard to allow access
to remove oil cooler assembly (1).
6. Remove plug (6, Fig. 2) from oil cooler (1) and
drain coolant into a suitable container. Reinstall plug
(6, Fig. 2) when coolant is completely drained.
7. Remove oil inlet line (7) from adaptor (11) in oil
cooler assembly (1). Drain any remaining oil in oil
inlet line (7) into a suitable container. If required,
remove adaptor (11) from oil cooler assembly (1).
8. Fit blanking cap to oil inlet line (7) and oil cooler
assembly (1) port to prevent ingress of dirt.
9. Remove oil outlet line (8) from adaptor (11) in oil
cooler assembly (1). Drain any remaining oil in oil
outlet line (8) into a suitable container. If required,
remove adaptor (11) from oil cooler assembly (1).
10. Fit blanking cap to oil outlet line (8) and oil cooler
assembly (1) port to prevent ingress of dirt.
4 - 'O' Ring
5 - Bolt
6 - Plug
1 - Heat Exchanger
2 - Water Inlet Flange
3 - Water Outlet Flange
Fig. 2 - Exploded View of Transmission Oil Cooler
5
3
4
1
3
6
4
2
5