Operation and maintenance manual

Section 170-0030
SM 2166 Rev 1 10-03
5
Parking Brake - Actuator
* * * *
adjustment screw (14) on the slack adjuster (3) until
the 1.5 mm total clearance is obtained.
10. Remove feeler gauge and apply brake several
times. The automatic slack adjuster will adjust the
brake pad clearance with each application, which can
be seen by the rotation of the adjustment screw (14).
11. When the adjustment screw (14) stops rotating, the
specified clearance of 0.7 - 1.0 mm has been obtained
and the brake is ready for normal operation.
12. Remove wheel blocks and place the steering lock
bar in the 'Stowed' position.
SPECIAL TOOLS
There are no special tools required for procedures
outlined in this section. Refer to Section 300-0070,
SERVICE TOOLS, for part numbers of general service
tools and adhesives required. These tools and
adhesives are available from your dealer.
SPECIAL TORQUE SPECIFICATIONS
TORQUE
FIG. NO. ITEM NO. ITEM NAME Nm lbf ft
1 10 Nut 115 - 136 85 - 100
2 6 & 35 Bolt 25 18
2 21 Joining Nipple 95 70
2 30 Bolt 3 -