Operation and maintenance manual

Section 165-0015
9
SM 2167 Rev 1 10-03
24
25
26
27
28
37
36
31
32
33
34
38
37
29
39
30
35
40
41
Note: To aid in assembly, moisten bore and 'O' ring
with a weak spirit/water mixture.
MAINTENANCE
WARNING
To prevent personal injury and property
damage, be sure wheel blocks, blocking
materials and lifting equipment are properly
secured and of adequate capacity to do the job
safely.
General
Every 1 000 hours (6 months), check the disc wear at
each brake assembly, as described in 'Inspection'.
Oil Change Period
Note: For recommended oils, refer to Section
300-0020, LUBRICATION SYSTEM.
Drain (preferably after a short run to warm the oil) oil
from brake coolant tank every 1 000 hours. Refer to
Section 250-0025, BRAKE COOLANT TANK. Remove
Fig. 24 - Brake Assembly/Axle Stub Installation
SM - 3111
Brake Assembly - Oil Cooled Disc Brakes
24 - Driveshaft
25 - Wheel Nut
26 - Stud
27 - Bearing Assembly
28 - Hub/Stub Face Seal
29 - Axle Stub
30 - Capscrew
31 - Oil Seal Spacer
32 - 'O' Ring
33 - Oil Seal Housing
34 - Ring
35 - Capscrew
36 - Capscrew
37 - Seal
38 - Hub
39 - 'O' Ring
40 - Brake Assembly
41 - Axle Housing