Operation and maintenance manual

Section 165-0015

SM 2167 Rev 1 10-03

9. Before separating the brake housing (31) and the

brake inner cover (15), ensure that the serial numbers

are stamped on both components. If no numbers are

found, match mark components to aid in reassembly.

Using suitable lifting equipment, lift the brake housing

(31) clear of cover (15).

10. Remove piston outer seal (20) from brake housing

(31) as shown in Fig. 10.

SM - 3097

Fig. 10 - Removing Outer Seal

11. Carefully remove piston inner seal (19) from brake

inner cover (15) as shown in Fig. 11. Remove 'O' rings

(17 & 18) from brake inner cover (15), along with wear

indicator pin (9) and 'O' ring (8).

SM - 3098

Fig. 11 - Removing Inner Seal

ASSEMBLY

Numbers in parentheses refer to Fig. 1, unless

otherwise stated.

WARNINGS

To prevent personal injury and property

damage, be sure wheel blocks, blocking

materials and lifting equipment are properly

secured and of sufficient capacity to do the job

safely.

1. Install 'O' ring (8) on wear indicator pin (9) and

lubricate. Insert pin (9) in brake inner cover (15) as

shown in Fig. 12.

2. Gently tap pin (9) into cover (15) until it is at the

correct depth as shown in Fig. 13.

SM - 3099

Fig. 12 - Installing Wear Indicator Pin

SM - 3100

Fig. 13 - Pin at Proper Depth

Brake Assembly - Oil Cooled Disc Brakes