Operation and maintenance manual
2-8
Pre-Starting
* If engine is to be started and run indoors, ensure proper ventilation to
remove deadly exhaust gases.
* Always perform 'Pre-Starting Inspection' instructions described on page 4-2
to ensure the vehicle is ready for operation.
* Always walk around the vehicle to make sure no-one is working on,
underneath or close to the vehicle before starting the engine or operating the
vehicle.
* Adjust, secure and latch the seat and fasten the seat belt before starting the
vehicle.
* Sound horn before starting the engine or beginning to move the vehicle; two
blasts for forward and three blasts for reverse.
Starting
* Do not start the engine or operate any control if there is a 'DO NOT
OPERATE' or similar warning sign attached to any control.
* Use jumper cables only as recommended. Improper use can result in battery
explosion or unexpected vehicle motion.
* Always obey 'Starting the Engine' instructions described on page 4-6.
* Do not bypass the vehicle’s neutral-start system. The neutral-start system
must be repaired if it malfunctions.
* Start and operate the vehicle only from the operator’s station.