Operation and maintenance manual
9-6
BODY
All welded construction, fabricated from high hardness
(min. 360 BHN) 1 000 MPa (145 000 lbf/in²) yield
strength steel. 25° tail chute angle provides good load
retention without tailgate.
Plate Thicknesses:
Floor and Tailchute ............................. 15.0 mm (0.59 in)
Sides .................................................... 12.0 mm (0.47 in)
Front .................................................... 10.0 mm (0.39 in)
Volume:
Struck (SAE) ..........................................14.5 m³ (19.0 yd³)
Heaped 2:1 (SAE) ................................. 19.5 m³ (25.5 yd³)
SERVICE CAPACITIES
Fuel tank ...........................................463 litres (122 US gal)
Hydraulic System
(Steering, Braking & Body) ............. 209 litres (55 US gal)
Cooling System ................................. 80 litres (21.1 US gal)
Engine Crankcase (with filters) ...........37 litres (9.8 US gal)
Transmission & filters (dry fill) ........... 56 litres (14.8 US gal)
Differentials - ZF (Front, Centre, Rear) 31 litres (8.2 US gal)
Planetaries - ZF ..................................... 9 litres (2.4 US gal)
Driveshaft Bearings ............................ 1.5 litres (0.4 US gal)
Air Conditioning Compressor ..... 0.125 litres (0.033 US gal)
Typical Noise Levels
Operator Ear (ISO 6394) ............................................80dbA
*Exterior Sound Rating (ISO 6395) ......................... 112 dbA
* - The above result is for the mode giving the highest
exterior sound level when measured and operated as per
the prescribed procedures of the standard. Results shown
are for the vehicle in base configuration.
Note: Noise Level Exposure to the operator and bystander
personnel may be higher depending upon proximity to
buildings, rock piles, machinery etc.. The actual job site
Noise Level Exposure must be measured and applicable
regulations complied with in respect to Employee Hearing
Protection.